Putting the devices into operation
12
Connecting devices to the input sockets
왘
Use a suitable cable to connect the output of an external device (e.g. a mixing console or an
additional SR 300 IEM G3) to the input socket
BAL AF IN L(I)
and/or
BAL AF IN R(II)
(see also page 13).
왘
Adjust the output level of your external device.
왘
Via the operating menu, adjust the transmitter’s input sensitivity. The input sensitivity is
adjusted via the “
Sensitivity
” menu item and is common for both inputs (see page 24).
Connecting devices to the output sockets
왘
Use a suitable cable to connect the input of an external device (e.g. a mixing console or an
additional SR 300 IEM G3) to the output socket
LOOP OUT BAL L(I)
and/or
LOOP OUT
BAL R(II)
(see also page 13).
Connecting a remote antenna to the BNC socket and positioning the antenna
Use a remote antenna when the transmitter position is not the best antenna position for
optimum transmission. You can choose between two antennas:
• A 2003 UHF passive directional antenna
• A 1031 passive omni-directional antenna
왘
Use a low-attenuation 50-
Ω
cable to connect the antenna to the transmitter.
왘
If possible, use a short antenna cable and as little connections as possible, since long
cables and many connectors lead to an attenuation of the antenna signal.
왘
Position the antenna in the same room in which the transmission takes place.
왘
Observe a minimum distance of 1 m between the antenna and metal objects (including
reinforced concrete walls).
Connecting the AC 3 antenna combiner to the BNC socket
To make multi-channel systems, you should use the AC 3 antenna combiner (optional
accessory). The AC 3 allows you to operate up to four transmitters with a single antenna
without virtually any intermodulation. In addition, the AC 3 incorporates DC distribution to
enable simultaneous powering of up to four transmitters via its BNC sockets.
왘
Connect the AC 3 antenna combiner to the BNC socket
.
PUSH
PUSH
L(I)
R(II)
BAL
AF IN
+22dBu MAX
The input amplifier of the SR 300 IEM G3 is designed for line level input.
L(I)
R(II)
+22dBu
MAX
Loop Out
BAL
0682
FREQ Range-D 780-822 MHz
DESIGNED AND MADE IN GERMANY FMO
Stereo Transmitter SR 300 IEM
IDENT NO 627925
SER NO 2518100155
IC 2099A-G3SREK
The signal received from the AF input sockets
BAL AF IN L(I)
and
BAL AF IN R(II)
is actively buffered and then routed to the output sockets
LOOP OUT BAL L(I)
and
LOOP OUT BAL R(II)
. The AF output sockets will therefore work only when the
transmitter is switched on and powered.
PUSH
R(II)
BAL
AF IN
+22dBu MAX
RF OUT
ANT
Содержание evolution wireless 300 IEM G3
Страница 1: ...300 IEM Series Instruction manual ...
Страница 2: ......