ACCESSORIES
CODE
DESCRIPTION
CU-A-MICROB
USM - micro USB 1 metre communication cable
CU-A-MICRO-OTG
Mobile phone adapter cable
Z-PC-DINAL2-17.5
Quick fit support for DIN rail - HEAD + 2 SLOT P = 17.5 mm
Z-PC-DIN2-17.5
Quick fit support for DIN rail - 2 SLOT P = 17.5 mm
Z-PC-DIN8-17.5
Quick fit support for DIN rail - 8 SLOT P = 17.5 mm
CONTACT INFORMATION
Technical support
Product information
This document is property of SENECA srl. Copies and reproduction are prohibited unless authorised. The content of
this document corresponds to the described products and technologies.
Stated data may be modified or supplemented for technical and/or sales purposes.
ADVANCED SETTINGS
•
Possibility to set current or voltage input.
•
Possibility to set the measurement scale values by adjusting ISM (measurement scale start) FSM (measure-
ment full scale): ± 10000 mV or ± 0 – 20000 μA
•
Possibility to set the measurement scale values by adjusting IST (technical scale start) FST (technical full
scale): ± 32000.
•
Possibility to enable or disable every single channel.
ATTENTION
The upper power supply limits must not be exceeded, as this might cause serious damage to the module.
Switch
the module off before connecting inputs and outputs.
To meet the electromagnetic immunity requirements:
•
use shielded signal cables;
•
connect the shield to a preferential instrumentation earth system;
•
separate shielded cables from other cables used for power installations (inverters, motors, induction ovens,
etc...).
•
install a fuse with a MAX capacity of 2.5 A near the module.
•
make sure that the power supply voltage to the module does not exceed: 40 Vdc or 28 Vac, otherwise the
module will be damaged.
8/8
