17
Doc# 2016-25-05 Rev F Technical Support 678-208-3087 Ext #1 Airtext Installation Manual
Standard ARINC-429 labels:
Label: 75 ACTIVE WAYPOINT FROM/TO DATA (DSC)
Label: 113 Message Checksum
Label: 125 GREENWICH MEAN TIME (BCD)
Label: 204 BARO CORRECTED ALTITUDE (Feet) (BNR)
Label: Mach number (BNR)
Label: 210 TRUE AIR SPEED (BNR)
Label: 260 DATE (BCD)
Label: 300 STN DECLINATION, TYPE AND CLASS (BNR)
Label: 301 MESSAGE CHARACTERS 7-9 (BNR)
Label: 302 MESSAGE CHARACTERS 10-12 (BNR)
Label: 303: Record (Message) Length/Type/Number
Label: 304: IDENT Characters 1 - 3
Label: 305: IDENT Characters 4 - 6
Label: 306: Waypoint Latitude
Label: 307: Waypoint Longitude
Label: 310 PRESENT POSITION LATITUDE (BNR)
Label: 311 PRESENT POSITION LONGITUDE (BNR)
Label: 312 GROUND SPEED (BNR)
Label: 351 DISTANCE TO DESTINATION (VIA FLIGHT PLAN) (BNR)
Label: 352 ESTIMATED TIME TO DESTINATION (VIA FLIGHT PLAN) (BNR)
Additional configuration specifies how the altitude is presented and if checksums are valid.
POST-INSTALLATION CHECKOUT
After Airtext is installed, complete the checkout procedures herein to verify proper basic operation.
Mounting, Wiring, and Power Checks
Check that Airtext is mounted rigidly. Do not connect Airtext to the aircraft harness until the following
checks have been performed:
1. Check that all cables are properly secured and shields (if used) are connected at one end only. Either to
the shield block of the connector at the Airtext router, at ONE of the disconnects, or at the far termination
of the cable. Check the movement of the flight and engine controls to verify there is no interference
between the cabling and control systems.
2. Prior to powering up Airtext, check the wiring harness for point to point continuity to expose any faults
such as shorting to ground or swapped pins. Any faults or discrepancies must be corrected before
proceeding.
3. After accomplishing a continuity check, perform power and ground checks to verify proper power
distribution to Airtext. Any faults or discrepancies should be corrected at this time. Remove power from