Track Your Truck Coyote EO Series, Installation Manual

Page: 1 / 2

Installation:
1. When installing the Coyote EO OBD-II GPS unit, be sure that the engine is off
2. First install the included Velcro tie strap running it behind the vehicle OBD-II connector (see
images 2 and 3 on the opposite side of the page). There’s typically a gap above the
connector where the strap will fit. Next plug in the tracking unit; note it will only fit one way.
Tighten strap and secure back on itself to prevent loosing.
3. An ODB extension cable has been provided for each unit in your order. If desired, you may
plug in the slightly larger ‘male’ end into the ODB port, and the other into the tracking unit
itself.
4. With the extension cable, the unit may be mounted on top of the dashboard, along the
driver’s side A-pillar, or completely behind the dashboard. Installation examples using the
extension cable are on the back of this page.
5. Start the vehicle. Note the engine must be running as the unit uses RPMs to detect Key On.
6. Ensure vehicle is outside and away from a building (i.e. not in garage, or shop facility).
7. The unit will begin to track. It sometimes takes 2-5minutes for the initial GPS reports to be
sent.
Coyote EO Series
Vehicle in for Service Note:
If a mechanic needs access to the OBD-II port on the vehicle, they can
disconnect the unit when the vehicle is off (engine off, ignition off). They
can then place the unit on the dash and read diagnostic codes from the OBD-II
port. Afterwards, they can reconnect the unit following the install procedure in
the section above.
Coyote EO Series Installation Guide
630 Wyndhurst Drive Unit D
Lynchburg, VA
815-717-8482
support@trackyourtruck.com
Tamper Alerting * :
Note that when the Coyote EO Series OBD-II GPS unit is disconnected from the
OBD-II port, it will send the “Main Power Disconnected” alert to indicate
tampering. Be aware of this when the vehicle is in for service.
*Coyote EO models with alerting: EOGB, EOHB, EOVB
Installation Verification
1.Go to install.tyt1.net . or Scan the QR Code to the right.
2.Record the ESN/Serial number associated with the GPS unit.
3.Record the Vehicle Identification Number (VIN)
4.Park the vehicle outside with a clear view of the sky.
5.Follow the prompts in the NetTrack Installer Check.
6.If the verification fails, Check the LED’s on the GPS unit.
And try again.
7.You may also contact TYT Support via our support site at
support.trackyourtruck.com
Please see reverse side for installation examples