Sencore MRD 7000, Руководство пользователя

Страница: 90 / 126

MRD 7000
– User Manual
Page 90 (126)
Satellite
Frequency 950 - 14500 The carrier frequency in MHz of the input
signal
LO Offset 0
5150
9750
10600
10750
11250
Choose or enter the frequency offset in
MHz based on the current input signal and
the above Satellite Frequency value
Symbol Rate 0.5
– 60
The symbol rate in MSps of the modulated
input signal
PL Scrambling
Code 0
– 262141
The PL Scrambling code value of the
modulated signal
LNB Power Off
13 VDC
18 VDC
Chose to enable LNB Power and specify
the output voltage that match the
application
22kHz Tone Enabled
Disabled
Enable/Disable the 22kHz tone based on
LNB Power configuration
Multi-stream State Enabled
Disabled
Enable/Disable the Multi-stream state
based on your current DVB-S2 input signal
ISI 0
– 255
The unique ID of the input signal within the
DVB-S2 multi-stream input signal
3.3.18 Configuring Decoder Output Modes
MRD 7000 allows a user to decode single UHD or Multichannel HD/SD outputs. The
two output types are SDI or SDI over IP specifically SMPTE 2110. The mode of
operation for the MRD 7000 will depend on the licensing and output card installed.
Multichannel mode (4 Independent HD/SD channels) is configurable when unit is
equipped with the MRD 70120, MRD 70140, MRD 70141, MRD 70180 or MRD 70182
module. Single Port/Link UHD for MRD 70141, MRD 70180 or MRD 70182. Quad Link
UHD for MRD 70140 or MRD 70141.
3.3.18.1 Configuring SDI Single Port UHD Decoder Outputs
To change from Quad Link UHD or Multichannel mode to Single Port UHD mode, the
user needs to select 12G-SDI + ASI (UHD) from the Module Configuration list. After
reboot, confirm Port 1 is set to SDI and Port 2 is set to ASI. Ports 3 and 4 should be
disabled.