47
ProBee-ZE20S Series User Guide Rev.0.1
TBD
Figure 6-4 Example #2: 1 Coordinator and 2 End Devices
6.5.1 Coordinator
Configuration
Hardware configuration for the coordinator is as follows:
•
Set the HOST switch to UART
•
Connect a serial cable between a host computer and the coordinator
The AT commands for coordinator configuration is as follows:
AT+NODETYPE=1
OK
AT+PANID=7772
OK
ATZ
OK
6.5.2 End-devices
Configuration
Hardware configuration for the coordinator is as follows:
•
Set the GPIO_OUT switch to LED_ON
The AT commands for the end devices are as follows:
AT+NODETYPE=4
OK
AT+PANID=7772
OK
AT+GPIO=3333333333333
OK
Содержание ProBee-ZE20S Series
