Semilac UV Lamp 36W, Инструкция по использованию

Страница: 9 / 16

1. DESCRIPTION OF THE DEVICE/INTRODUCTION
Before starting the device for the first time, please read the manual carefully. After
reading keep the manual for reference in case of doubts.
Thank you for choosing our product. The device was designed for professional nail art
and should be used only for the curing of UV gels and hybrid varnish. The manufacturer
is not responsible for damages resulting from the incorrect use of the lamp and from
ignoring the contents of this manual.
2. DEVICE INFORMATION
Before the first stat-up of the device check whether the kit contains all the necessary
components. The kit is composed of: 4 UV fluorescent tubes and a 36W UV lamp (remo-
vable light reflecting pad, non-removable cable with a length of approximately 140 cm
with the plug, two rocker switches: I/O and 120 secs, Timer Off, 180 secs and one Time
Start switch with a LED). Make sure that the mains voltage required to operate the device
(rating plate data) is the same as the mains voltage at the location where the device is to
be used (correctly installed socket with a 230 V supply voltage).
1. The device was constructed solely for the curing of gel and hybrid varnish.
2. The lamp was equipped with a timer selection switch with three options: 120 secs/180
secs/timer off.
3. You can order the spare parts for the device with the seller/distributor.
4. To ensure proper hygiene the pad on which the palm rests should be disinfected.
3. DEVICE OPERATION
1. Place the 4 UV fluorescent tubes in the sockets (A).
2. Before starting the device make sure the local mains voltage is the same as the voltage
required for the operation of the device specified in the device data. Place the mains
plug in the socket.
3. To start the device, press the rocker switch (C) to the “I” position, the LED on the time
switch (E) will light up red. To turn off the lamp, switch the rocker switch to the “0”
position.
4. Select appropriate operation duration, using the time selection switch (D). Three valu-
es are available for selection (120 secs/180 secs/timer off).
5. To start the timer, press the timer start button (E).
6. An example of operation time use:
Example uses of the device with the appropriate time are presented below. Remember
that these are just approximate values and may differ in reality:
Single phase gel and 3-phase gel:
Classic single phase gel and 3-phase gel have a standard curing time of 2 minutes.
Set the timer to 120 Secs and press the timer start button (E). Remember that if you
use 3-phase gel, you need to cure base and top separately.