Semilac UV Lamp 36W, Инструкция по использованию

Страница: 10 / 16

Finishing and gloss gel:
The finishing and gloss gels have a curing time of 3 minutes. Set the timer to 180 Secs
and press the timer start button (E).
Hybrid varnish:
As a standard each layer of the hybrid varnish is cured over 120 seconds. Set the
timer to 120 Secs and press the timer start button (E).
Base:
As a standard base under gel is cured over 60 seconds. Set the timer to 120 Secs and
press the timer start button (E). Remove your hand from the lamp after 60 seconds.
Top:
As a standard top is cured over 3 minutes. Set the timer to 180 Secs and press the
timer start button (E).
If during the treatment you feel a burning sensation in the vicinity of the nail plate
and try to repeat it after 5 minutes. If the situation repeats, contact the lamp seller/
distributor.
4. UV FLUORESCENT TUBE REPLACEMENT
Do not replace the UV fluorescent tube if it is hot or when the device is connected to
power. If the replaced fluorescent tube did not operate, before consulting the distributor
check:
1. Is the lamp correctly connected to power supply.
2. Is the device switched on: the ON position “I”.
3. Did the timer start LED (E) light up red.
4. Is the lamp fuse (B) functional; replace if necessary.
5. Replace the fluorescent tube with a new one, to make sure whether the previous one
was defective.
5. DEVICE MAINTENANCE INDICATIONS
1. Keep the inside of the device clean. Remove all the remains of the used products.
2. Clean the device enclosure using a slightly damp cloth. Protect the device against hu-
midity entering its enclosure.
3. Use fluorescent tubes which are in accordance with the technical data in the operation
manual and on the device rating plate.
4. Only use the device in accordance with its use.
5. Protect the device against shocks and impacts. They may result in permanent damage
to the device or the fluorescent tubes.