pg. 3
Introduction
Safety and Compliance
This document provides instructions to install the ChargePro™ 620 Charging Station and should not be
used for any other product. This product must be installed in accordance with the National Electrical Code
(NEC), the Canadian Electrical Code (CEC) or any applicable local code.
Review this manual and consult a licensed contractor and/or electrician before installation to ensure
compliance with local building practices, climate conditions, safety standards, and state and local codes.
The ChargePro™ 620 Charging Station should be installed by a licensed contractor/ electrician and
inspected by a qualified installer prior to initial use. Under no circumstances will compliance with the
information in this manual relieve the user of responsibility to comply with all applicable codes and safety
standards.
This document describes the most common installation and mounting methods. Contact SemaConnect
where it is not possible to perform an installation using the procedures provided in this document,
SemaConnect is not responsible for damages that may occur or result from installations that are not
described in this document.
General
The ChargePro™ 620 Charging Station is grounded through a dedicated conductor to the ground
connection at the power distribution panel.
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy. This equipment may cause harmful interference with radio
communications if not installed and used in accordance with the manufacturer’s instructions.
Any Changes or modifications to this product not authorized by SemaConnect, Inc., could affect FCC
compliance and revoke your authority to operate this product.
The power output of the radiating components in this device is below the FCC radio frequency exposure
limits for uncontrolled equipment.
Statements
Reasonable effort has been made to ensure that the specifications and other information in this manual are
accurate and complete at the time publication. However, specifications and other information in this manual
are subject to change at any time without prior notice.
Use of the ChargePro™ 620 Charging Station in a manner not intended or any modification not approved
by the manufacturer will void the limited warranty. Other than the limited warranty, SemaConnect products
are provided “AS IS,” and SemaConnect and its distributors expressly disclaim all implied warranties,
including any warranty of design, merchantability, and fitness for a particular purposes and non-
infringement, to the maximum extent permitted by law.
IN NO EVENT SHALL SEMACONNECT, INC. OR ITS AUTHORIZED DISTRIBUTORS BE LIABLE FOR
ANY INDIRECT, INCIDENTAL, SPECIAL, PUNITIVE, OR CONSEQUENTIAL DAMAGES, INCLUDING
WITHOUT LIMITATION, LOST PROFITS, LOST DATA, LOSS OF USE, COST OF COVER, OR LOSS OR
DAMAGE TO THE CHARGEPRO™ 620 CHARGING STATION ARISING OUT OF OR RELATING TO
THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF SEMACONNECT, INC. OR ITS AUTHORIZED
DISTRIBUTORS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
