pg. 21
Installer Supplied Materials
Straps to secure the Wall/Pole Mount Bracket Plate
Installation Instructions
1) Check Boxes for Correct Content
2) Pre-Installation Preparation
NOTE:
Ideally, the conduit should run internally through the pole from the distribution panel to the
wire-hole location. However, if external conduit is used, there is an opening on the side of the
Wall/Pole Mount Bracket Post for the wires.
Prepare the Pole
1. On the selected pole cut 1 inch diameter
hole 30 inches from the ground level (Check
local codes).
2. Run the wires from the distribution panel to
the opening created on the pole as shown in
illustration. Ensure that that free end of the
wire extends at least 18” outside the pole.
Site Selection
The charging station should be positioned
such the distance between the charging
station and electric vehicle is sufficient to
minimize likelihood of damage (suggested
min. 3 ft). Two alternatives are illustrated
here.
