SELMI Demoulding, Руководство пользователя и обслуживания

Страница: 12 / 54

DEMOULDING
8
1.7. Details of the manufacturer
The machine described in this instruction manual was built
by:
SELMI S.r.l.
Via Statale, 151 – 12069 – S. Vittoria D’Alba (CN) Italia
Tel. 0172.479273 - 0172.479275 - Fax 0172.477814
www.selmi-group.it - info@selmi-group.it
1.8. Identification plate of the machine (CE marketing)
There is a plate, similar to the one shown here, on the
machine, indicating details of the manufacturer, the CE
conformity mark and the machine’s serial number. Always
state this number when communicating with the
manufacturer.
Example of identification plate on the machine structure
TYPE
SERIAL NUMBER
YEAR
WEIGHT
1.9. Identification plate of the CE marking electric panel
(low voltage)
Example of identification plate on electrical panel. The correct
data shown in the section on the machine’s technical
specifications.
1.10. Inteded use
This machine is designed to carry out the automatic
demoulding of pralines or bars that are held inside moulds.
The production rate of this machine is 4 moulds per minute. It
can, as an option, be loaded manually but it achieves a very
high performance and productivity rate if combined with the
SPIDER cooling tunnel. The moulds are automatically
demoulded onto a rigid surface at the exit of the tunnel,
hence avoiding manual intervention from the operator.
The mat will carry the product to the wrapping machine or to
the packaging line.
The machine needs to be connected to compressed air with
a pressure of 6 BAR and 100 litres/minute.
Warning
A use other than that specified is considered
improper. The machine is intended for professional
use only.
Attention
Do not place any small objects near the control panel
or the tank: they could fall and enter the tank, which
would contaminate the product.
1.11. Operating environment
To guarantee proper functioning the machine must be
protected from atmospheric agents. Its ambient operational
temperature should be between 15C° and 25C° with relative
humidity not exceeding 70%.
The working environment must be clean, sufficiently
illuminated and away from an explosive environment.
The environmental characteristics of the installation site are
specified in section 4.
Attention
The machine’s fixed guards have a variety of
openings to allow the internal units to cool. When the
machine is running, make sure that these openings
are not covered by cloths or objects that obstruct
proper air flow.
1.12. Noise level
The phonometric tests carried out on this specific machine
model show an acoustic pressure lower than 70 dB(A).