SmartBox
®
MINI
22 / 36
INSTALLING THE SMARTBOX MINI
Before installation, check that the product is complete and has not suffered any damage
during transport.
ASSEMBLY, STARTUP and MAINTENANCE are to be carried out by a company
specialised in terms of water law.
The specialised company and the operator must observe, comply with and understand all of
the following instructions in this assembly and operating manual. For the system to function
as intended, it must be installed professionally in compliance with the technical rules
applicable to the planning, construction and operation of the entire system.
These regulations also include the accident prevention regulations of the employers’ liability
insurance associations, the VDE regulations, and the installation and operating instructions.
Installation instructions
The display unit has a wall installation housing and is operated with the top of the housing
closed. Installation and start-up by a specialised installer is carried out with the display unit
open.
Installation of the digital display unit
1. Loosen the screw on the bottom of the digital display unit and remove the top of the
housing.
2. Place the digital display unit on a suitable position on a smooth, vertical wall and pierce
the pre-cut holes on the inside back wall of the housing. Mark the points for installation.
Do not damage electronic components.
Use a suitable tool to pierce the openings.
3. Place the digital display unit on the marks and fix it in place using the supplied anchors
and screws.
4. Close the top of the housing and tighten the screw on the bottom of the digital display unit.
TROUBLESHOOTING
Fault cause
Action
Battery warning Battery _ _%
when remaining capacity is
low
Constant check
No display
Batteries empty
Replace batteries
Error code
Meaning
Error 0001
No contact with FSA-E:
Check the connection between the magnetic sensor and
the magnetic encoder in the connection plug on the
FSA-E.
Reset.
Error 0002
Connection cable on the digital display unit not connected:
Connect the cable.
Reset.
Reset: remove/insert batteries
