5)
6)
7) Tighten the locking screw and confirm that the suspension pipe A and fastening ring don't turn.
8) Tighten the fixing nuts on the suspension hardware.
■
Special Direct Mount Type
1) Fix the fitting on the mounting surface firmly.
2)
3)
4) Raise the lamp house gently and tighten the reflector fixing screw.
5)
■
Stanchion Type
1)
2) Fix the clamp with the clamp fixing screw.
3)
4)
5)
■
Replacement demand type
1)
2)
Connect the power wires inside the existing junction box.
3)
NB:
■
Precautions in leading the cable into the terminal box
1) The cable gland must be a product specified by SEIWA.
2) For the use of a metal conduit, be sure to provide a sealing fitting near the terminal box.
Fix the stand pole completely with the pole fixing hardware and box
mounting screw.
If the lighting fitting is provided with a flexible terminal box, skip the
above steps 2
）
to 4
）
. In that case, connect the cable (use the black
wire for grounding) inside the terminal box.
After connection of the power cable(white and brown:power wire,green:grounding wire), unhook the suspension hook and place it in the
terminal box cover.
Fit the terminal box cover onto the terminal box and turn the fastening ring 90 degrees until the protrusions (red marks) align with each
other.
Loosen the reflector fixing screw and open the lamp house gently
until it is supported by the chain. The lamp house can be opened
down to 90 degrees by removing the chain snap from the chain
retainer.
Lead the applicable cable into the fitting through the cable gland and
connect the power cable.
The white and red wires are power wires and the black wire is a
grounding wire.
Pass the lead wire through the stand pole and insert the pole into
the terminal box in the arrow direction.
Tighten the locking screw on the terminal box. Confirm that the box
does not turn.
Attach the joint box and short nipple to the bottom of the stand
pole.
Pass the cable from the lighting fitting through the existing
suspension pipe and junction box and attach the pipe and box to the
fitting.
If the lighting fitting is used in a place where water may splash on it,
waterproof the joint between the fitting and the existing suspension
pipe.
Holes
Mounting Interval: 500
Holes
×
12Oblong Holes
(only for the flexible terminal box)
Cable and Protective Tube
(not supplied)
Lamp House
(cable supplied with the
flexible terminal box)
Fitting Body
Chain Snap
Reflector Fixing Screw
Cable Gland
Chain Retainer
ジャンクション
Clamp Fixing Screw
Support (not supplied)
Clamp Holder
Terminal Box
Stand Pole
Fitting
Clamp
Joint Box
(not supplied)
Locking Screw
Short Nipple G3
／
4
Existing junction box
Existing suspension
Existing suspension
Cable
Fitting
- 2 -
