Seiler Evolution Zoom, Руководство пользователя

Страница: 13 / 36

13
ATTENTION: Please take care when connecting cables as the connector pins are fragile.
CAUTION: The grounding terminal must be connected to an active grounding point.
Failing to do so may cause electrical shock, damage the device or cause it to NOT operate properly.
PLEASE NOTE: The device is immune to electromagnetic radiation within the limits specified under the EN
60601-1-2 standard and the updated version of IEC 60601-1-2.
Using the microscope
Using the microscope
ATTENTION: Before any attempt to operate Seiler Evolution Zoom Microscope, please read
carefully and thoroughly the present User’s Guide. This device may only be used by qualified
personnel.
Moving the Unit
The
Seiler Evolution Zoom Microscope
has been designed to be easily adjusted and handled whilst also
ensuring maximum comfort and stability.
Before using the
Seiler Evolution Zoom Microscope , one can move it from one place to another and change
the position of the main modules to meet specific demands, since the followings instructions are considered
(Figure 10 and Figure 11):
To move the microscope with the base to the desired place, release the brakes of the 4 swivel casters. Move
the microscope by the column. After the base is placed on the required place, press the brakes for locking the
wheels.
The level of the base can be set using the Knob to raise or down the swivel casters, so as to place them on a
horizontal plane (Figure 10).
To adjusting the optical system to a specific position, make sure the swivel casters are properly locked (Figure
10). Then, loosen the knobs indicated and place the optics in the required position (Figure 11). After that, re-
tighten the Knobs (do NOT over-tighten them).
It is preferred to place the optical module as near as possible do the column, for improving stabilization.
To rotate the optical module vertically, release knob E. This may be slightly difficult, since the system is
assembled with a preload to prevent the optical module from falling/rotating involuntarily (Figure 2 and Figure 11).
The knob E is set in factory for a specific range of load. When many accessories are assembled, it may be
necessary to increase its preload, adjusting the disc spring washers of the brake mechanism of the knob E
(chapter 8) for greater stiffness. This shall be accomplished according to the following steps (Figure 12):
• Remove the cover indicated.
• Disassemble the screw and the knob E.
• Take apart the disc spring washers 1 and 2.
• Disassemble the body part.
• Apply additional torque to the adjusting nuts in such a way that they increase the preload on the disc spring
washers 3 to 8. Then, low strength thread-locking compound shall be applied to the adjusting nuts to prevent
them from loosing.
• Reassemble all the mechanism, apply low strength thread-locking compound to the screw assembled into the
knob E.