Seiki SC-610AUGCT, Инструкция по эксплуатации

Страница: 14 / 24

14
GAS CONNECTION
• Make sure that it is possible to run gas lines to the gas connection point of the
appliance. The gas connection point must be accessible without having to
remove the cooktop. If a flexible hose is used, the connection point must also
be accessible without having to remove the cooktop.
• Using the supplied gas regulator (A), remove the dust seals on the inlet and
outlet ports and position the “OUT” port of the regulator towards the gas inlet
pipe of the cooktop, as shown (B). Using a suitable threat sealand, screw the
regulator on and ensure that it is orientated with easy access to the test point
(C). Connect the appropriate gas supply to the “IN” port of the gas regulator.
GAS CONVERSION
This gas cooktop is fitted out for use with Natural Gas (NG). If it is to be used
with liquefied petroleum gas (LPG), the burners have to be converted. The
conversion must only be carried out by a qualified professional. Before starting
the conversion , make sure all gas is switched off (and preferably disconnected
from the appliance) and the electrical power has been disconnected.
• Remove the burner heads, caps and rings from each burner as. Using a
socket spanner undo the injector from each burner and replace the correctly
rated injector as shown in, opposite.
• Adjust the low flame, opposite. Light the burner and turn the knob to the
LOW position. Remove the knob from the corresponding valve shaft by simply
pulling it off the shaft. Insert a small screwdriver into the shaft and open the
bypass screw from the closed position, opposite. Replace the knob.
• After the conversion, the adjustment data plate at the bottom of the appliance
should be replaced with the new one (supplied), which corresponds to the
new gas adjustment.
NOTE:
To convert the appliance back for use with Natural Gas,
perform the above steps but using the NG injectors.
INSTALLATION (Cont.)
A B C