Section 5: Operations
Operating All Models
2015 Sacksafoam I Operations Manual
(Version E)
16
4.
All air trapped in the sack must be removed,
otherwise the Bambi bucket may not sink
when dipped in the water. If the sack is lying
on the ground, excess air can be removed by
opening the vents on each side and pressing
down in the centre of the sack. Close the vents
tightly after exhausting all of the air.
5.
Replace the cam lock filler plug.
6.
Remove the cam lock cap from the foam outlet
port. An internal check valve ensures foam is
dispensed only while the injection pump is
operating.
Removing the Sack from the Bucket
1.
Reverse installation sequence.
2.
If there is any appreciable amount of foam left in the sack, it should be pumped out until the pump
runs dry. At this point the sack can be easily removed from the bucket. The remaining foam
(approximately four litres with the 8018 sack) can be removed through the drain port.
3.
The sack should be flushed with fresh water and pumped out. This will also clean the pump.
Drain any residual water through the drain port.
4.
Clean off the outside of the sack to remove any foam residue.
Vent
Important Note
Proper cleaning of the sack prior to storage will increase the life span of the unit.
UNCONTROLLED COPY IF PRINTED
