Segway RMP 210 V3, Руководство пользователя

Страница: 42 / 50

42
Batteries
RMP 210
Transportation and Shipping
Lithium-ion batteries are regulated as "Hazardous Materials" by the U.S. Department of Transportation. For more information,
contact the U.S. Department of Transportation at
http://www.phmsa.dot.gov/hazmat/regs or call 1-800-467-4922. See
"Transportation and Shipping," p. 19.
Proper Disposal
The Li-ion batteries used in the Segway RMP can be recycled. Recycle or dispose of batteries in accordance with local environmental
regulations. Do not place in fire or incinerate. For more information, contact Segway at 1-866-4SEGWAY (1-866-473-4929), or visit
our website at
http://rmp.segway.com.
Installation and Removal Instructions
WARNING!
Unplug or disconnect your Segway RMP from AC power before removing or installing batteries or performing any service. It is
hazardous to work on any part of your RMP when it is plugged into AC power. You risk serious bodily injury from electric shock as well
as damage to your RMP.
Install and remove the batteries in a dry location only.
Removing Batteries
Tool required: 3 mm hex wrench.
1. Tip the RMP onto its side so one wheel lies flat against a clean, smooth surface.
2. Use a 3 mm hex wrench to remove the fasteners (four per battery).
3. Pull the batteries straight off the chassis.
Installing Batteries
CAUTION!
Replace battery fasteners every time a battery is installed. Use only Segway-approved fasteners. Failure to replace fasteners
jeopardizes the watertight seal of the RMP. To avoid risk of damage, do not use power tools.
NOTICE
Do not cross thread or over-tighten fasteners. Tighten only to the prescribed torque. To avoid risk of damage, do not use a power tool
to thread in or tighten fasteners. Use only Segway-approved fasteners.
Tools required: 3 mm hex wrench.
Torque wrench
1. Tip the RMP onto its side so one wheel lies flat against a clean, smooth surface.
2. Seat the batteries on the chassis with the curved edge facing the outside of the chassis.
3. Secure the batteries to the chassis with fasteners (four per battery, install center fasteners first) and tighten with a 3 mm
hex wrench. Torque fasteners to 1.6 N-m (14 in-lbf).
Replacing Batteries
Whenever you replace a propulsion battery, consider replacing all propulsion batteries. Replacing only one battery will not
necessarily increase the performance or range of your Segway RMP because it is designed to operate only at the level allowed by the
lower-energy battery. Therefore, you should replace all propulsion batteries together (except in the unusual situation where a battery
is replaced because of damage or defect and the others are relatively new).