Segway RMP 210 V3, Руководство пользователя

Страница: 27 / 50

27
User Manual
Charging
Characteristic Value
Input Voltage 100 – 240 VAC, 50 – 60 Hz
Input Current 12 A Maximum
Output Voltage 57 – 95 VDC
Output Current 2.1 A per channel
Table 7: External Power Supply Input/Output
Figure 21: User Interface Panel
Using the External Power Supply
An External Power Supply is supplied with the RMP.
The charge port (Connector IV) is located on the interface panel next to
the Charger Status LEDs.
1. Make sure the ambient temperature is between 10°–50° C
(50°–120° F) and humidity is less than 90% non-condensing.
2. Make sure the RMP is powered off.
3. Connect the External Power Supply to the charge port on the
RMP (Connector IV).
4. Plug the power cord into the IEC connector on the External
Power Supply and into a grounded AC outlet (100 – 240 V, 50 –
60 Hz).
5. Toggle the power switch on the External Power Supply to the ON
(l) position.
6. Charge new batteries for 12 hours. To fully charge in-use
batteries, charge for about two hours.
7. When charging is complete, toggle the power switch to the OFF
position, unplug the External Power Supply from the grounded
AC outlet, and disconnect the External Power Supply from the
RMP.
Figure 22: External Power Supply
Charging
WARNING!
Do not plug in the charger if the charge port, power cord, or AC power
outlet is wet. You risk serious bodily injury or death from electric shock as
well as damage to the RMP.
CAUTION!
Failure to charge the batteries could result in damage to the batteries.
Left unplugged, the batteries could fully discharge over time, causing
permanent damage. Use only charging devices approved by Segway.
CAUTION!
Do not connect or disconnect the External Power Supply while it is
powered ON. Doing so could damage the RMP.
The RMP 210 requires the External Power Supply to charge the batteries.
This power supply converts AC power to DC power for use by the RMP.
The Smart Charger Board inside the RMP distributes this power as
needed to the batteries for charging.
Charging requires the temperature to be within 10°–50° C (50°–120° F)
and the humidity be <90%, non-condensing.