Sega THE HOUSE OF THE DEAD III DELUXE, Руководство оператора

Страница: 36 / 112

28
www.seuservice.com
29
www.seuservice.com
5. PRECAUTIONS TO BE HEEDED WHEN MOVING THE MACHINE
●
Do not move the product with a GD-ROM disk inside. Remove the
GD-ROM disk before moving the product.
●
Failure to observe this instruction may cause the GD-ROM disk and/or GD-
ROM drive to be damaged.
●
Do not hold or press the plastic parts as indicated by the Figure 7C. Failure to
observe this instruction may break the parts, and eventually the broken pieces
may cause a personal injury.
●
When moving the machine, be sure to pull out the plug from the power supply.
Moving the machine with the plug as is inserted can cause the power cord to
be damaged and could result in a fire and or electric shock.
●
When moving the machine on the floor, retract the Adjusters and ensure that
Casters make contact with the floor. During transportation, pay careful atten-
tion so that Casters do not tread power cords and earth wires. Damaging the
power cords can cause an electric shock and or short circuit.
●
In places where step-like grade differences exist, be sure to separate the PTV,
PTV Cabinet, and the Controller Cabinet. Inclining the PTV as is mounted
on the PTV Cabinet can cause the PTV to fall off from the Base and result in
injury.
●
When lifting the cabinet, be sure to hold the catch portions or bottom part.
Lifting the cabinet by holding other portions can damage parts and installation
portions due to the empty weight of the cabinet, and cause personal injury.
●
When moving the PTV, do not push it from the rear side. Push it from side-
ways. Pushing the PTV from the rear side can have the PTV fall down, caus-
ing personal injury etc. In case the floor has slanted surfaces or step-like
differences, be sure to move the machine by 2 or more persons.
Do not push PTV from the back. Pushing the PTV from the
back can cause the PTV to fall down. Push it from the side.
WARNING!
CAUTION!
When moving the Cabinet, do not hold or push on the Gun Holder, as this may de-
form or damage the part.
STOP
IMPORTANT!