Seepex BN 17-12S, Руководство по эксплуатации и сборке

Страница: 60 / 86

54
9.2 Reassembly
A / 07.11.2019 - OM.SCT.BN.S03EN 27/36
9.2.3.3 Assemble rotating unit (RTE)
Cut off holding band (406, 407) for material
design stainless steel, heat-resistant steel
Universal joint sleeve can be damaged by
hammering and striking. Joint grease (GF) can leak
out. Avoid hammering or striking the universal joint
sleeve.
 Refer to the technical data (

chapter 3) for the
material design.
 Cut off holding band (406, 407) below holding
band loop (SCL) .
– Use tool (WBS) .
 File down and deburr any projecting edges.
 The holding band (406, 407) must lie in the
groove of the universal joint sleeve (405) .
 Replace the holding band (406, 407) if the
holding band (406, 407) slips back through the
loop.
 Slide shaft seal casing (SEA) onto plug-in shaft
(307) .
– See chapter Shaft seal reassembly
(

chapter 9.4).
 Moisten inner surface of splash ring (310) and
outer surface of plug-in shaft (307) with anti-
seize graphite petroleum (GC) for easier
assembly of the splash ring (310) .
 Slide splash ring (310) onto plug-in shaft (307) .
– Observe fitting position of splash ring (E)
(lettering „SEA“).