CW3 INDIRECT COOLER INSTALLATION MANUAL | 15
CONTROL CABLE PATH
The communications cable should be hanging loose on the
outside of the dropper.
INSTALLATION CABLE CONNECTIONS
ILL3029-B
Feed the control cable through the rear access hole (RHS) from
the underside of the tank.
The control cable needs to be routed though the cable tray on
the inner wall of the tank, and then fed through to the control
module.
Important! Ensure the mains cable is not submerged or
touching the water in the tank at any point along the cable
length. Make use of the resealable cable restraints. Cable
tie to existing looms if necessary.
Remove the Control Module cover.
Connect the Wall Control communications cable to the free
socket labelled “Comms”.
Connect the Drain Valve cable to the connector/pins labelled
“Drain”.
Replace the cover.
Clip the loose cables into the restraint on the rear tank hole
to lock them into place and then insert the plug provided from
inside the tank.
•
This will seal the hole in the tank.
Push the remainder of the loose cables back down into
the dropper. Leave some slack on the cables so they sit
comfortably.
ILL3109-A
ILL3110-A
UNDERSIDE VIEW
TOP VIEW
ILL3112-A
UNDERSIDE VIEW
ISOLATION
SWITCH
ILL3111-D
WALL CONTROL CABLE
DRAIN VALVE CABLE
INSTALLATION
CONNECTIONS
ILL3111-D