47
5.11.4
Clear Logs
Clears the logs stored in the flash memory.
Press the
Up
and
Down
cursor keys to the desired log to be cleared and press the
Enter
button.
A message prompts for confirmation.
After confirmation the logs are cleared and the following information message appears:
5.11.5
Walk Test
Initiates a silent or audible Walk Test. The following occurs when in Walk Test mode:
•
Generates a non-latching trouble that clears after exiting the walktest.
•
Cancelling the walk test is done by pressing the
Cancel
button or if no circuit activations
are detected for one hour.
•
Zone indicators, including the Smart Relay Module (SRM-312) function normally during
the test, displaying the input status when it is activated.
•
Other Relays and signal correlations to input circuits are not processed during walk-test.
Correlations to system status will still be processed.
•
All common controls and keys not explicitly required for the walk-test operation are
disabled while the walk-test is active.
•
The alarm verification and waterflow retard operation is disabled on inputs during walk-
test.
During an Audible walk test:
•
activating any input activates all signals for half a second.
•
Trouble on any input activates all signals continuously for 5 seconds. After the code is
transmitted, the input resets (if resettable) and is tested again. If it is still in alarm or
trouble the code will be re-transmitted.
C r t A d d P a r m # V a l
1 0 0 0 0 1 0 0 2
2 0 0 0 0 2 0 3 4
3 0 0 0 0 2 0 0 3
Select Log
1. Alarm Log
2. General Log
3. All Logs
Clear all the
Selected log (s)?Y/N
Log(s) cleared
