SafeLogic Xtreme Installation and Operation Instructions
Doc. No. XU-EC1501A-X151123
SecuRam Systems Inc.
Page 7
Step 5: Now that the cam is oriented correctly, remove the spindle (Part# MSP-15A-6IN).
Step 6: The spindle (Part# MSP-15A-6IN) has one end that is drill and tapped to receive the
Spindle Bolt (Part# M4*16). This drilled and tapped hole will be used to connect the
spindle to the DialRing. Locate the drilled and tapped hole end of the spindle and insert
this end of the spindle into the spindle insertion point as seen below. Ensure that the
spindle is inserted through the clear plastic spindle tube.
Step 7: Continue to push the spindle into place until it reaches the DialRing hub.
Step 8: At the DialRing, insert the Spindle Screw (Part# M4*16) into the DialRing hub and
tighten.
Caution:
a.
Ensure that the cable is held taught while inserting the spindle. Make sure the cable will not
be crimped by the spindle.
b.
Make sure the spindle can smoothly slide into the hub of the DialRing. If the spindle does not
engage into the hub, reposition the DialRing to allow the spindle to properly align with the
hub.
