SECOMP ROLINE ProSecure II 1000 VA, Руководство пользователя и инструкция по установке

Страница: 54 / 58

24
Trouble shooting
Displayed on LCD Audible Alarm Alarm Description What You Should Do
Output Overload Two Beeps per
second The UPS is overloaded (in
Line Mode). Your
equipment needs more
power than the UPS can
provide. The UPS operates
in bypass. Shut off the least important
equipment connected to the
UPS. If this solves the
overload problem, the UPS
will switch from bypass back
to normal operation.
Battery Test No Beeps The UPS is doing a battery
test. No action needed. The UPS
will return to normal operation
when it successfully completes
the battery test.
Over-Charge Constant beep Batteries are
overcharged. Turn off protected loads. Turn
off UPS and call your local
dealer
Low Battery 2 beeps every
5seconds The unit is operating on
Battery Power and will shut
down soon due to very low
battery voltage The unit will restart
Automatically when
acceptable power returns.
On-Battery Once every 5
seconds The unit is operating on
Battery Power. Save your data and perform a
controlled shutdown.
Charger Failure Constant beep Charger has failed. Phone the local dealer
Over-Temperature Constant beep High ambient Temperature. Make sure the unit’s fans and
vent holes are not blocked, and
make sure the ambient
surrounding temperature is not
above 40 degree C. If these
conditions did not solve the
problem, call your service
representative.
Output Short Constant beep Output short circuit Call the Local dealer
High output Voltage Constant beep High output voltage Call the Local dealer
Low Output Voltage Constant beep Low output voltage Call the Local dealer
Bus Fault 2 Beeps per
second High internal DC bus
Voltage. Turn off protected loads. Turn
off UPS and call your local
dealer
Site wiring Fault 1 Beep per
second Voltage detected Between
Neutral and Ground UPS mains connector polarity
Wrong. Rotate the connector
(Schuko). UPS installed to
mains supply without ground.
See page 15 on how to disable
the Site wiring alarm
Line abnormal 1 Beep per
second Wrong AC Line backed up
during auto restart