SECOMP ROLINE ProSecure II 1000 VA, Руководство пользователя и инструкция по установке

Страница: 48 / 58

18
RS-232 Standard Interface port
The RS-232 interface uses a 9-pin female D-sub connector. This information consists of data about utility, load and the UPS.
The interface port pins and their functions are identified in the following table.
Pin # Signal name Direction (re UPS) Functions
2 TxD Output TxD Output
3 RxD Input RxD / Inverter Off Input
5 Common Common
6 CTS Output Ac Fail Output
8 DCD Output Low Battery Output
9 RI Output +8-24 VDC Power
USB port
Connecting the UPS to your computer is accomplished through the USB port on the back of your
computer. USB compliant hardware and operating system will be necessary including installation of a
UPS driver. The serial port cannot be used when using the USB port. The USB cable is standard and can
be bought separately.
EPO port
(emergency power off)
A customer-supplied switch located remotely can be used to open the EPO connection and allows UPS
output receptacles to be switched off. Since the EPO shuts down the equipment immediately, orderly
shutdown procedures are not followed and not by any power management software. The UPS will have to
be manually restarted in order to regain power to the outlets.
Network Transient protector
The network transient protector, located on the back panel, has both IN and OUT jacks, and houses a
single RJ-45 (10BaseT) network connector. Connect the input connector to the jack labeled IN, and the
output connector to the jack labeled OUT.
Load segments
The power management software controls the sets of receptacles known as load segments which provides
organized shutdown and startup of the equipment. Less critical equipment can be turned off during power
outages saving battery power for critical loads. The power management software manual has more details
regarding this. The load group status can be viewed from the LCD display and can be changed if
necessary. These load segments are usually handled with the UPS management software. Refer to chapter
5.2 regarding the two load segments that come with each model.
Caution! Max rated values
24Vdc/50mA