Seco Udoo X86, Руководство пользователя

Страница: 34 / 61

X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
34
3.3.12 UDOO Bricks connector
This connector, managed by the Intel
®
Curie microcontroller, allows augmenting features offered by the
UDOO x86 board, by adding the UDOO Bricks external sensor modules.
The connector used is type MOLEX p/n 53398-0571 or equivalent, with the pinout shown in the table
on the left.
Mating connector: MOLEX 51021-0500 receptacle with MOLEX 50079-8000 female crimp terminals.
ALERT#: I2C Bus Alert. Input Signal, electrical level +3.3V_C. It is managed through the Intel ® Curie Sensor
Subsystem
’
s GPIO #0
C_SDA0: I2C data line. Bidirectional signal, electrical level +3.3V_C with 10k
Ω
pull-up resistor. It is managed by the
Intel
®
Curie Sensor Subsystem
’
s I2C port #0
C_SCL0: I2C clock line. Bidirectional signal, electrical level +3.3V_A with 10k
Ω
pull-up resistor. It is managed by the Intel ® Curie Sensor Subsystem
’
s I2C port #0
3.3.13 SPI Header
This pin header, managed by the Intel
®
Curie microcontroller, has been implemented in order to
allow the compatibility with existing Arduino sketches.
The connector, CN16 is an internal 10-pin standard right angle male pin header, p 2.54 mm, h= 6.1mm.
SPI_MISO: SPI Master In Slave Out input signal, electrical level +5V_C. It is managed through the Intel
®
Curie
SPI master port #1
SPI_MOSI: SPI Master Out Slave In output signal, electrical level +5V_C. It is managed through the Intel
®
Curie SPI master port #1
SPI_CLK: SPI Clock output signal electrical level +5V_C. It is managed through the Intel
®
Curie SPI master port #1
RESET: Sketch reset input signal, electrical 5V_C
3.3.14 ARDUINO int expansion connectors
On four dedicated female headers p.2.54mm are realised both the Arduino 101 interface (managed by the Intel
®
Curie microcontroller) and the expansion
interface, managed by the Intel
®
Braswell SoCs.
On the
“
internal
”
rows of these headers is implemented the Arduino interface, while on the
“
external
”
rows are available the expansion interfaces.
This will allow the plugging of Arduino 101-compatible sketches on these connectors, while leaving the further expansion interfaces free for use.
UDOO Bricks connector CN24
Pin Signal
1 +3.3V_C
2 ALERT#
3 C_SDA0
4 C_SCL0
5 GND
SPI Header - CN16
Pin Signal Pin Signal
1 SPI_MISO 2 5V_C
3 SPI_CLK 4 SPI_MOSI
5 RESET 6 GND