X86
UDOO X86 User Manual - Rev. First Edition: 1.0 - Last Edition: 1.0 - Author: S.B. - Reviewed by M.B. Copyright © 2017 SECO S.r.l.
51
4.5
Power menu
Menu Item
Options
Description
Advanced CPU Control
See submenu
These items control various CPU parameters
EC Watchdog Configuration
See submenu
Embedded Controller Watchdog Configuration Settings
Thermal Zone configuration
See submenu
Thermal Zone Configuration: Active and Passive Cooling Settings.
Power Fail Resume Type
Always ON
Always OFF
Determine the System Behavior after a power failure event.
In case the option is
“
Always ON
”
, the board will start every time the power supply is present.
When the option is
“
Always OFF
”
, the board will not start automatically when the power supply returns.
A CMOS Battery is required to support this feature, otherwise the chipset default setting is Always ON.
WiFi on M.2
Enabled / Disabled
Enables or disables the WiFi capabilities of WiFi cards plugged into M.2 slot CN19.
Bluetooth on M.2
Enabled / Disabled
Enables or disables the BT capabilities of BlueTooth cards plugged into M.2 slot CN19.
Instant OFF
Enabled / Disabled
In non-ACPI environments, this item will enable the system shut-down by a power button pressure.
Curie Power Management
Enabled
Wake Only
Disabled
Enables or disables the system power-on and power-
signal (CN13 pin 3, active low 20ms pulse).
When
“
Wake Only
”
ly be able to wake the system from S3/S4/S5
depending on OS configuration) and wake from it
Power on Intel Curie
Enabled / Disabled
If enabled, it will power-on the Arduino interface
Curie reset on Power On
Enabled / Disabled
-
power state (S3/S4/S5)
Infrared Support
Enabled
Wake Only
Disabled
Enables or disables the system power-on and power-off managed by the Infrared Remote Control.
When disabled, the Infrared Receiver will be unconditionally disabled.
When
“
Wake Only
”
, the Infrared Receiver will only be able to wake the system from S3/S4/S5
When enabled, the Infrared Receiver will be able both to put the system in a low power state (S3/S4/S5,
depending on OS configuration) and wake from it
Wake on PME
Enabled / Disabled
Determines whether the system must wake up or not when the system power is off and occurs a PCI
Power Management Enable wake-up event (e.g. to enable Wake on LAN feature).
