ENFORCER Fingerprint Reader and Keypad
14
SECO-LARM U.S.A., Inc.
User codes may be assigned to user IDs between 1001 and 2998 for common users, and 2999
and 3000 for super users. When programming user codes, use the following general formula after
entering base programming mode (see "Enter and Exit Base Programming Mode," pg. 9):
– After a short beep, you may continue to add users
by repeating these steps, but without repeating the function code
.
– Add Users function code (LED will change to steady orange)
–
to
– 1998 unique user IDs for user codes to trigger the device (and 2
super user IDs for super user codes to toggle between disable and enable user access)
– User code – 4~6 digits long
NOTES:
•
Each User ID must be unique and cannot be repeated for multiple user fingerprints or codes.
•
Additional users may be entered in succession without repeating the function code
.
•
To return to base programming mode to program other functions, press the
key (the LED
will flash red) followed by the function code for that function (LED becomes steady orange).
•
Exit programming mode by pressing the
key after all programming is completed. One beep
will sound and the LED will return to steady red. After 25 seconds of inactivity, the keypad will
automatically exit programming mode and return to standby.
Examples:
1.
Program user code
for User ID #1001:
2.
Program user code
for User ID #2750:
3.
Program two user codes – 67890 for User ID #2015, and 654321 for User ID #2017
wait for beep, then
NOTE:
The add user function code places you into this programming mode. Press the add user
function code only before adding the first user. To continue to add other users in the same
session, do not repeat the add user function code .
Programming User Codes:
