ENFORCER Fingerprint Reader and Keypad
10
SECO-LARM U.S.A., Inc.
Programming the Master Add/Delete Fingerprints (Continued):
Programming the Master Programming Code:
In this manual, the format used for programming the keypad is as follows:
•
A single-digit
(
) FUNCTION CODE to tell the keypad what is being programmed.
•
A varying number of digits (
) to represent the parameters of that FUNCTION.
•
The
key to confirm programming of the FUNCTION and exit to base programming mode.
•
The
key to exit programming mode and return to standby mode.
The following is a list of the different programming functions:
Function
Code*
Parameters
Default Functions and Values
Page #
0
Master programing code
Default 123456, code length 6 digits
10
1
Add user codes/fingerprints
No default, must be programmed
11~14
2
Delete user codes/fingerprints
No default, must be programmed
15~16
3
Output mode/time
Momentary 5 seconds
16~17
4
Access mode / security level
Either user code or fingerprints
17~18
5
Wrong-code lockout / external alarm
Lockout disabled, alarm enabled 1 minute
19, 21
6
Keypad sounds / interlock system / door
propped-open/forced-open notification
Sounds enabled, interlock disabled, door
open notification disabled
18~20,
24~25
7
Set device ID for Wiegand controller
0
22~23
8
Set Wiegand output bits/format
Output bits 26, output bits 4
23~24
*Press the function code only to enter the programming mode for that function. It should not be
repeated between each parameter.
Programming Format and Default Values:
The master programming code is used to enter programming mode. The master programming
code does not serve as a user code to activate the keypad output.
1.
Make sure the keypad is in base programming mode (see "Enter and Exit Base Programming
Mode
,
" pg. 9).
2.
Enter the new master programming code (6 digits):
(where "X" is the new master programming
code)
3.
Exit programming mode:
Press the
key or wait 25 seconds to exit automatically.
NOTE:
Programming the master add/delete fingerprints also resets the keypad to factory default.
Though all user information is retained, the master code will return to the default 123456,
and other settings will return to the default. Because of this, if you desire to use the master
add/delete fingerprints, it is best to program them before programming any other settings.
