Practical tips
Snow chains
Snow chains must only be fitted
to the front
wheels
, even on vehicles with
four-wheel
drive
.
●
Check that they are correctly seated after
driving for a few yards; correct the position if
necessary, in accordance with the manufac-
turer's fitting instructions.
●
Keep your speed below 50 km/h (30 mph).
●
If there is a danger of being trapped de-
spite having mounted the chains, it is best to
disable the driving wheels (ASR) in the ESC
›››
page 270, Connecting and disconnect-
.
Snow chains will improve
braking ability
as
well as
traction
in winter conditions.
For technical reasons snow chains may only
be used with the following wheel rim/tyre
combination.
Tyres
Wheel rim
Chains
215/60 R16
6Jx16 VAS 43
Max. link 15 mm
215/55 R17
7Jx17 VAS 45
215/50 R18
7Jx18 VAS 45
225/55 R17
7Jx17 VAS 45
Max. link 9 mm
225/50 R18
7Jx18 VAS 45
225/45 R19
8Jx19 VAS 45
Other dimensions do not allow chains
Remove any central wheel trims before fitting
snow chains.
WARNING
The use of unsuitable or incorrectly fitted
chains could lead to serious accidents and
damage.
●
Always the appropriate snow chains.
●
Observe the fitting instructions provided
by the snow chain manufacturer.
●
Never exceed the maximum permitted
speeds when driving with snow chains.
CAUTION
●
Remove the snow chains to drive on
roads without snow. Otherwise they will im-
pair vehicle handling, damage the tyres
and wear out very quickly.
●
Wheel rims may be damaged or scratch-
ed if the chains come into direct contact
with them. SEAT recommends the use of
covered snow chains.
Tyre pressure monitor sys-
tem
Control lamp
It lights up
The inflation pressure of one or more wheels is much
lower than the value set by the driver, or the tyre has
structural damage.
In addition, a audible warning sounds and a text
message is displayed on the instrument panel
screen.
Stop the vehicle!
Stop the vehicle safely as soon
as possible. Check all tyres and pressures. Replace
any damaged tyres.
Flashes
System fault
The control lamp flashes for approximately 1 minute
and then lights up permanently.
If the tyre is inflated correctly, switch the ignition off
and on again. Re-calibrate the tyre pressure monitor
indicator
. If the fault continues, go to a
specialised workshop.
Several control and warning lamps light up
for a few seconds when the ignition is
332
Содержание Ateca 2020
