Seat Ateca 2020, Руководство пользователя

Страница: 166 / 376

Operation
Remote control LED
When the buttons are pressed, the LED of re-
mote control
›››
Fig. 148
2
gives the user a
range of information:
It lights up for approx. 2 seconds
●
In green: The auxiliary heater has been
switched on using the

button.
● In red: The auxiliary heater has been
switched off con with button

.
Flashes slowly for approx. 2 seconds
●
In green: No on signal has been received.
The remote control is out of range. Move
closer to the vehicle.
●
In red: No off signal has been received. The
remote control is out of range. Move closer to
the vehicle.
It flashes irregularly
● In green: The independent heating is
blocked. Possible causes: the fuel tank is al-
most empty, the 12-volt battery charge is
very low or there is a fault.
It lights up or flashes steadily
●
In orange (then in green or in red): The re-
mote control battery is almost flat. However,
the on or off signal has been received.
●
In orange (then flashes green or red): The
remote control battery is almost flat. No on or
off signal has been received.
Flashes for around 5 seconds
●
In orange: The remote control battery is flat.
No on or off signal has been received.
Range
The range of the remote control is a few hun-
dred meters when the battery is fully charged
and under optimal conditions.
● A distance of at least 2 m must be left be-
tween the remote control and the vehicle.
●
There should be no obstacle between the
remote control and the vehicle.
●
Secure the remote control with the chrome
pin
›››
Fig. 148
1
vertically facing upwards.
●
Do not cover the antenna.
The range of the control is considerably less
in poor weather conditions, if there are build-
ings in the vicinity or if the battery is low.
Changing the remote control battery
If the indicator lamp does not come on, the
remote control's battery must be replaced.
● Insert a suitable tool, e.g. a screwdriver, into
the indentation in the remote control housing,
in the direction of the arrow
›››
Fig. 148 .
●
With the help of the same tool, lift the lid
until the housing locking element is released.
●
Slightly move the cover in the direction of
the arrow.
● Remove the cover.
●
To remove the battery, carefully insert a
tool like a screwdriver into the indentation
next to the battery.
●
Use the screwdriver to lift up the battery un-
til it releases from its housing.
●
Remove the old battery.
●
Insert a new battery of the same type and
make sure it clicks into place. When inserting
the battery, make sure that the polarity is cor-
rect.
●
Fit the cover onto the remote control hous-
ing.
●
Slide the cover in the direction opposite to
the arrow until it clicks into place
›››
Fig. 148 .
WARNING
Swallowing a battery with a 20 mm diame-
ter or any other button battery can cause
serious and even fatal injuries within a very
short time.
●
Always keep the remote control, keyrings
with batteries, the spare batteries, button
batteries and all other batteries over 20
mm out of reach of children.
●
If you suspect that someone may have
swallowed a battery, seek immediate med-
ical attention.
164