Emergencies
Raising the vehicle
Fig. 186
Crossbar: marks.
Fig. 187
Strut: mounting the jack on the vehi-
cle.
–
Place the jack* (vehicle tools) on a firm sur-
face. If necessary use a large, strong board
or similar support. On a slippery surface
(such as tiles) place the jack on a rubber
mat or similar to prevent it from slipping.
.
–
Find the support point on the strut (sunken
area) closest to the wheel to be changed
. The jack* support point is be-
hind the mark on the strut.
–
Turn the jack*, located below the strut sup-
port point, to raise it until tab
1
is below the housing provided.
–
Align the jack* so that tab
1
“grips” onto
the housing provided on the strut and the
mobile base
2
is resting on the ground.
The base plate
2
should fall vertically with
respect to the support point
1
.
–
Continue turning the jack* until the wheel
is slightly lifted off the ground.
WARNING
●
Make sure that the jack* remains stable. If
the surface is slippery or soft, the jack* could
slip or sink, respectively, with the resultant
risk of injury.
●
Only raise the vehicle with the jack* sup-
plied by the manufacturer. Other vehicles
could slip, with the consequent risk of injury.
●
Only mount the jack* on the support points
designed for this purpose on the strut, and
always align the jack correctly. If you do not,
the jack* could slip as it does not have an ad-
equate grip on the vehicle: risk of injury!
●
The height of the parked vehicle can
change as a result of variations in tempera-
ture and loading.
CAUTION
The vehicle must not be raised on the cross-
bar. Only place the jack* on the points de-
signed for this purpose on the strut. Other-
wise, the vehicle may be damaged.
Removing and fitting a wheel
Change the wheel as described below after
loosening the wheel bolts and raising the ve-
hicle with the jack.
Taking off the wheel
–
Unscrew the wheel bolts using the box
spanner and place them on a clean surface.
–
Take off the wheel
.
Putting on the spare wheel
When fitting tyres with a compulsory rotation
direction, observe the instructions in
.
–
Mount the wheel.
–
Screw on the wheel bolts in position and
tighten them loosely with a box spanner.
–
Carefully lower the vehicle using the jack*.
–
Tighten the wheel bolts in diagonal pairs
using the wheel brace.
The wheel bolts should be clean and turn
easily. Before fitting the spare wheel, inspect
»
219
Tec
hnic
al s
pec
ific
ation
s
Adv
ic
e
Oper
ation
Saf
ety
The e
ssenti
al
s
Содержание 2014 LEON CUP RACER
