Seagull Models P-26A PEASHOOTER, Инструкция по сборке

Страница: 35 / 38

35
3) Position the pilot figure on the cock-
pit floor as shown. Use epoxy to glue the
base of the pilot figure, please see pictures
as shown.
Epoxy.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
APPLY THE DECALS.
INSTALLING BATTERY - RECEIVER.
1) Plug the servos leads and the switch-
lead into the receiver. Plug the battery
pack lead into the switch also.
2x6mm
2x6mm
2) Wrap the receiver and battery pack in
the protective foam rubber to protect
them from vibration.
Receiver.
Battery.
BALANCING.
1) It is critical that your airplane be
balanced correctly. Improper balance will
cause your plane to lose control and
crash. THE CENTER OF GRAV-
ITY IS LOCATED 120MM BACK
FROM THE LEADING EDGE OF
THE WING AT THE WING ROOT.
2) Mount the wing to the fuselage. Place a
piece of masking tape on the top of each
wing 120mm back from the leading edge
at the wing root.
3) With the model inverted, place your
fingers on the masking tape and carefully
lift the plane. This is the point at which
your model should balance for your first
flights. Later, you may wish to experi-
ment by shifting the balance up to 10mm
forward or back to change the flying
characteristics.