Seagull Models P-26A PEASHOOTER, Инструкция по сборке

Страница: 16 / 38

P-26A Peashooter
Instruction Manual.
16
4) Test fit the stopper assembly into the tank.
It may be necessary to remove some of the
flashing around the tank opening using a
modeling knife. If flashing is present, make
sure none falls into the tank.
5) With the stopper assembly in place, the
weighted pick-up should rest away from the
rear of the tank and move freely inside the
tank. The top of the vent tube should rest
just below the top of the tank. It should not
touch the top of the tank.
6) When satisfied with the alignment of the
stopper assembly tighten the 3 x 20mm ma-
chine screw until the rubber stopper expands
and seals the tank opening. Do not over-
tighten the assembly as this could cause the
tank to split.
FUEL TANK INSTALLATION.
You should mark which tube is the vent
and which is the fuel pickup when you attach
fuel tubing to the tubes in the stopper. Once
the tank is installed inside the fuselage, it may
be difficult to determine which is which.
8) Slide the fuel tank into the fuselage. Guide
the lines from the tank through the hole in
the firewall.
9) Use balsa block to hold in place the fuel
tank with epoxy to secure the fuel tank in-
side the fuselage.
7) Use balsa block to hold in place the fuel
tank with epoxy to secure the fuel tank in-
side the fuselage.
Epoxy
Epoxy.
Balsa block- front.
Balsa block- back.
10) Connect the lines from the tank to the
engine and muffler. The vent line will con-
nect to the muffler and the line from the
clunk to the carburetor.