OWNER
’
S MANUAL
(
SEA ISUZU FSR/FSD EV)
SEA-OWS-QA-004/5
ISSUE DATE:
30/05/2020
Page
21
of
56
Disconnecting the Charge Cable
➢
Once the charge cable is plugged into the charging socket, a safety lock is activated to prevent the
cable dislodging.
➢
To unplug before full charge is reached (during charge), the ignition switch must be turned to ON. This
will disconnect the charging circuits and unlock the charging cable from its socket.
➢
Note that the truck cannot be started while the charging cable is connected to the truck. Turning the
ignition switch to ON will stop the charging process but the SEA-Drive® system will not power up until
the charge cable is physically disconnected from the truck.
➢
If for any reason the charge socket will not disengage when the vehicle ignition is activated, the charge
socket has an emergency release toggle on the rear. First, the vehicle isolator switch should be
disconnected and removed from the vehicle to de-energise all power. The charge cord should also
have power disconnected and cord removed from the wall connection. Next, gain access to the rear
of the socket and change the red lock lever position to unlock (or pull the metal cable based on the
socket model). The charge cord can then be released from the vehicle socket.
See Appendix A at the end of manual as SOP, showing Charging process of the SEA-Drive®.
