Sea Tel 5012-91, Руководство по установке, Страница: 87 / 138

Codan Mini-BUC Ethernet M&C Install & Operation 5012-91 Installation Manual
16-1
16. Codan Mini-BUC Ethernet M&C Install & Operation
Below are general instructions only. Please refer to your Codan Manual for more detailed instructions, updated information and
a complete list of commands.
16.1. Cable Installation
1. Connect one end of an Ethernet
cable to the Ethernet connector on
the CFE computer (or to a CFE router
or CFE LAN Hub which the computer
can access).
2. Connect the other end of the
Ethernet cable to the Ethernet port
on the rear panel of the MXP.
16.2. Setting up the IP address and subnet mask in the computer.
The options that you see depend upon the version of Microsoft Windows® that you have installed (Windows® XP is
described below). The steps to set the computers IP address may be different in your version of Windows®.
If you are using a network computer, consult your IT department/representative for proper IP address & subnet mask
settings, of the computer, the MXP and the BUC, that will be compatible with your existing LAN.
To set up an IP address and subnet mask in
a single, dedicated, Windows XP computer:
1. Click Start.
2. Select Settings—Control Panel—Network Connections:
3. Double-click on the network that you want to use from the list of available networks under LAN or High-
Speed Internet
.
4. In the Local Area Connection Status window, click on
Properties
.
5. Scroll through the listed components used by this connection, select
Internet Protocol
(TCP/IP), then click
on
Properties
.
6. Select Use the following IP address, then enter an IP address that is within the same subnet
(192.168.xxx) as the Mini-BUC. For example, to communicate with the default settings of the Mini-BUC,
type 192.168.0.14
CAUTION: Do not use the same IP address as the Mini-BUC (192.168.0.12) for the IP address of the
computer. The last set of digits in the IP address must be different, for example, 192.168.0.13 and
192.168.0.14.
7. Enter an appropriate subnet mask. For example, type 255.255.255.0
8. Click on
OK
or
Close
in each window to save the settings and close each window.