Sea Tel 5012-91, Руководство по установке, Страница: 25 / 138

Installation 5012-91 Installation Manual
3-5
14. Remove the clamp bar and Roxtec® Multidiameter®
blocks from their cable mounting frame in the cable
passage channel.
15. Remove the rubber bar from the top of the Roxtec®
Multidiameter® blocks.
16. Remove the Roxtec® Multidiameter® blocks from
the cable mounting frame.
17. Pass the coaxes and power cable through the cable
mounting frame.
HINT: Again, It may be easier to connect, or tie-wrap,
the coaxes and power cable temporarily.
18. Re-install the cable mounting frame onto cable
passage channel using the four screws and flat
washers that were removed in step 7 above. .
19. Peel layers out of the upper and lower Roxtec®
Multidiameter® blocks to provide an opening in the
block that is just smaller than the outer diameter of
the cable that will pass through it. When
compressed the block should provide clamping force
on the cable and prevent it from moving in the block.