Sea Tel 5012-91, Руководство по установке, Страница: 45 / 138

Setup – Using the Commission Wizard 5012-91 Installation Manual
5-5
12. In the Zone entry field(s), type in a read only
descriptive name of said blockage.
13. In the
REL start
entry field(s), type in the
starting relative azimuth position of defined
zone. NOTE: This is the more counter
clockwise positional value, as referenced to the
bow of the vessel.
14. In the REL end entry field(s), type in the
ending relative azimuth position of defined
zone. NOTE: This is the more clockwise
positional value, as referenced to the bow of
the vessel.
15. In the
EL
entry field(s), type in the Elevation
angle of defined zone. NOTE: This elevation
angle is based on beam center of the radome
and the highest point of the blocking structure.
16. Click on “
Next
”.
The
Satellite Selection
section allows you to select or
define the satellite in which the system will use for the
remainder of the commissioning process.
For more information, refer to the Setup – Satellite
Configuration chapter.
17. Click on “ Add ” to create a new satellite preset.
NOTE: If this system has been previously
commissioned, as may be the case if the wizard is being
used as part of a post-install maintenance procedure
and/or repair, you may use the Satellite Selection drop
down menu to select a pre-existing satellite
18. Using spacecraft information, as provided by
the service provider:

Type in Satellite Name (you are
defining the preset name)

Type in the
Longitude
(orbital)
position and then use the drop down
menu selection to determine
East/West for this preset.
 Type in the L-Band tracking
Frequency for this preset. .

Type in the known satellite
Skew
for
this preset.
 Using the drop down menu selection,
define the
Transmit Polarity for this
preset.

Using the drop down menu selection,
define the required LNB
Band
of
operation for this preset.
 Using the mutually exclusive radio
buttons, define whether to use the
Xpol or CoPol LNB for tracking
purposes.
19. Click on “ Next ”.