Sea Tel 5012-91, Руководство по установке, Страница: 42 / 138

5012-91 Installation Manual Setup – Using the Commission Wizard
5-2
1. On the welcoming page, click on “ Start ”.
In the Network Configuration section, you will configure
the MXP’s Network information.
2. Enter in the desired IP address, Subnet Mask
and Gateway for the MXP’s four port
unmanaged switch (J3 A/B & j4 A/B).
Note:
Although any class IP address may be used, ABS
based installations must set these values to be on the
same subnet mask as the interfaced satellite modem.
3. Click on “Next”.
The MXP Serial Port section allows you to configure the
MXP’s bps settings for serial based communications with
various 3
rd
party devices (i.e. laptop, Out of Band
Management devices, etc).
4. Select the applicable baud rate using the drop
down menu selections list for the port in which
you are defining.
5. Click on “ Next ”.
The Gyro section allows you to define that type of Gyro
Compass (if any) integrated with the MXP. For more
information, refer to the Setup – Ship’s Gyro Compass
chapter.