Sea Recovery Ultra Whisper Compact 400, Руководство пользователя

Страница: 47 / 120

If the freshwater flush assembly is installed, the freshwater flush will start 2 minutes after shut down. When
the freshwater flush starts there will be a click and a green light will illuminate on the LCD screen. The
time delay after shut down is to allow the R.O. Boost depressurize.
The freshwater flush is equipped with a solenoid valve, that clicks open allowing the boats freshwater supply
to flush the system. The freshwater flush cycle will last for approximately 10 minutes. The 10-minute
cycle is adjustable on LCD controller. After the freshwater flush cycle is complete, the LCD screen will say
stand-by. Every 7 days the freshwater flush rinse cycle will repeat automatically.
If the “START/STOP”
button is pressed twice, the automatic freshwater flush cycle will be cancelled, and the
freshwater flush lamp will not be illuminated. To manually start the freshwater flush system, hold down
the freshwater flush button for 10 seconds and release, there will be a click and will run a full cycle.
3. Close the Inlet Sea Cock Valve. This is a safeguard for vessel installations.
4. If the freshwater flush is installed and activated, do not interrupt power. If the freshwater flush is not
installed or is not activated, turn off the electrical power source (circuit breaker) to the system. This
eliminates the chance of inadvertently starting the system. If the power source has been turned off, the
freshwater flush will not cycle every 7 days.
Maintenance Schedule
Maintenance Timetable:
COMPONENT MAINTENANCE
REQUIRED
TIME INTERVAL
CONTINUOUS
REPLACE INTERVAL
Sea Strainer Inspect & Clean
Screen & Housing weekly 100 hours
Plankton Filter Inspect & clean weekly 100 hours
Pre-filter Replace element(s)
Low Pressure <10 psi (0.68
BAR) Low Pressure <10 psi (0.68
BAR)
Air/Oil Separator
Orifice
Inspect & clean 3-6 months 500 hours
Feed Pump Inspect 3-6 months 700-1000 hours
R.O. Boost Inspect 3-6 months Rebuild 400-500 hours
R. O. Membrane Clean Element
When production or salt
rejection decreases by 10%
Salinity Probe Clean Probes Annually
Transducer Inspect Annually
Charcoal Filter Replace Element 3 months 3 months
pH Neutralizing
Cartridge Replace Cartridge when calcium carbonate
granules are depleted
UV Sterilizer
Replace lamp & clean
quartz sleeve
2000 Hours 2000 Hours
Fresh Water Flush
Charcoal Element Replace Element 3 months 3 months
4
5
System Daily Operation