Sea Ray 390 Sundancer, Руководство пользователя

Страница: 180 / 184

390 Sundancer
® (425 Sundancer ® )
9.4
S
ECTION
9 • C
ARE
& R
EFINISHING
10. A
CRYLIC
P
LASTIC
S
HEETING
(P
LASTIC
G
LASS
)
Never use a dry cloth or duster or glass cleaning
solutions on acrylic.
To clean acrylic, first flood it with water to wash off
as much dirt as possible. Next, use your bare hand,
with plenty of water, to feel and dislodge any caked
dirt or mud. A soft, grit-free cloth may then be used
with a nonabrasive soap or detergent. A soft sponge,
kept clean for this purpose, is excellent. Blot dry
with a clean damp chamois.
Grease and oil may be removed from acrylic with
kerosene, hexane, white (not aviation or ethyl)
gasoline or aliphatic naphtha (no aromatic content).
Do not use solvents such as acetone, silicone
spray, benzine, carbon tetrachloride, fire
extinguisher fluid, dry cleaning fluid or lacquer
thinner on acrylic, since they attack the surface.
Remove fine scratches with fine automotive acrylic
rubbing and polishing compounds.
11. C
ANVAS AND
C
LEAR
V
INYL
Do not fold or store any of the canvas pieces while
wet. All canvas should be rolled or folded when dry and
stored in a clean, dry place. For clear vinyl pieces, the
recommended methods for storage are rolling or laying
down flat. The clear vinyl should never be folded or
creased as cracking will result. To protect the clear vinyl
from rubbing against itself while rolled or stored flat, place
a piece of very soft, nonabrasive cloth between the
pieces. If the surface of the clear vinyl becomes
scratched, the canvas manufacturer has provided a
canvas care sheet located in your Owner’s Manual Packet.
When storing the rear (aft) curtain, fold the canvas over
the clear vinyl window (do not fold clear vinyl), then roll
or store flat.
The fabric should be cleaned regularly before substances
such as dirt, pollen, etc. are allowed to accumulate on
and become embedded in the fabric. The fabric can be
cleaned without being removed from the installation.
Simply brush off any loose dirt, particles, etc.; hose down
and clean with a mild solution of a natural soap in lukewarm
water (no more than 100°F, 38°C); rinse thoroughly to
remove soap. DO NOT USE DETERGENTS. Allow to
completely dry.
Wash and clean vinyl windows with a warm soap solution.
Use a soft cloth or sponge and do not scratch the surface.
If you have stubborn cleaning cases, call your dealer for
proper procedures. Do not try your own cleaning
procedures as they may permanently damage the canvas.
After each use, especially in salt water areas, rinse the
canvas completely with fresh cold water. Then let the
canvas dry completely before stowing.
All metal components of the canvas should be rinsed
with fresh cold water and exposed components wiped
dry to maintain appearance and working order.
Always clean spots, stains, etc., immediately. Test
an unseen area of fabric before cleaning stain, to
insure that cleaning material will not cause damage.
NOTICE
13. I
NTERIOR
U
PHOLSTERY
F
ABRIC
Cleaning and maintenance information provided by the
material manufacturer, is in your Owner’s Manual Packet.
REFER TO THE OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND OTHER CLEANING INFORMATION.
12. E
XTERIOR
U
PHOLSTERY
F
ABRIC
Exterior fabrics should be cleaned with a sponge or very
soft scrub brush and a mild soap and warm water solution.
After scrubbing, rinse with plenty of cold, clean water
and allow the fabric to air dry in a well ventilated place,
preferably away from direct sunlight.
Mildew can occur if your boat does not have adequate
ventilation. Heat alone will not prevent mildew; you must
also provide for fresh air circulation.
REFER TO THE OWNER'S MANUAL PACKET FOR
INSTRUCTIONS AND WARRANTY INFORMATION.