950-0206revE
- 24 -
February 12, 2015
b. If the wall control is to be used, plug it in now (CN9 blue connector) and route cable
out through rubber plug on the side of the unit.
Plug cable in at CN9. Thread rest of cable through grommet.
c. Remove corner covers 4 places. They can be pushed out from the back.
Push out corners to gain access to hanging rod nut.
d. Pull all the wire hangers out so they are accessible.
Wire hanger extended.
e. Make sure all wiring is to the center of the unit and not pinched between grille and
unit.
f. Secure the wire hangers to hanger brackets. The first 2 to secure would be the 2 that
face inward.
Wire hanger and hook secured.
g. Slightly tighten these 2 screws.
h. For the other 2 hangers, press down on the corners and hook the hangers onto the
brackets.
