![background image](http://html.mh-extra.com/html/sea-breeze/high-efficiency-smzca1218gr/high-efficiency-smzca1218gr_installation-and-user-manual_1220983011.webp)
950-0206revE
- 11 -
February 12, 2015
Remove the air filter.
•
Pull the handle behind the air inlet grill, raise it, and
disassemble. Then remove the three purifiers fixed on
the filter. See Figure 2.
Clean the filter
You can either use a vacuum cleaner, or wash them with warm
water and let dry. If the filter is too dirty (like oil stain on it), use
some warm water with neutral detergent to clean it, and then let it
dry.
NOTE:
•
Do not use water above 113 ºF to wash filter, it can deform the filter.
•
Do not place the filter near fire, it might catch fire or cause deformation.
2. Reinstall the air filter
Replace the filter on the two tabs on the top of the air inlet grille
. Pull the handle behind the air
inlet grill toward inside to fix filter. See Figure 3 below. Close the air inlet grill. (Refer to the first
step above.) Replace 2 screws.
NEVER OPERATE THE UNIT WITHOUT FILTERS!
Figure 3
Figure 4
3. Cleaning the Air Inlet Grill
Open the air inlet grill (same as the first step of Clean the Air Filter process above).
Take out the air filter (same as the second step of Clean the Air Filter process above).
Take out the air inlet grill. Open the air inlet grill on an angle of 45°, as shown in Figure 4
above, and then raise it.
Clean the air inlet Grill with soft brush, water and neutral cleaning, and then dry it after
cleaning.
Replace the air inlet grille. Refer to the process above.
Replace the air filter.
Close the air inlet grill.
4. Clean the Outlet Vent and Surface Panel
● Clean the surface panel with soft dry cloth or wet cloth with neutral scourer.
● Do not clean surface panel with gasoline, benzene, diluents, cleansing powder etc..
● If the louvers are too dirty, it can be removed to be cleaned by following the process below.
Disassemble and re-install the guide louver
Remove the louver by gently pressing down on the center of the louver while supporting the end
being removed. When tab is removed, slide opposite end out of hole.
Re-install the louver. Reverse procedure for assembly.
Figure 2