SDMO 6500 TE, Инструкция по эксплуатации и техническому обслуживанию, Страница: 22 / 212

7.5. Cleaning the air filter
Never use petrol or solvents with a low flash point for cleaning the air filter element (risk of fire or explosion).
Important
n
Remove the nut & the air filter cover (fig. D – No.1 & 2).
o
Remove the wing nut and the filter elements (fig. D – No. 3, 4 & 5) to clean them:
Foam element:
1) Wash the element in a household cleaning solution & hot water, then rinse thoroughly.
OR: Wash it in a non-flammable or high flash point solvent. Allow the element to fully dry.
2) Dip the element in clean engine oil and remove the excess oil.
Note: The engine will emit smoke during initial start-up if too much oil remains in the lather.
Paper element:
1) Gently tap the element several times on a hard surface in order to remove the excess dirt.
OR: Blow compressed air through the filter, inside-out.
Never try to remove dirt using a brush.
2) Replace the paper element if it is too dirty.
p
Carefully check that the two elements are not torn or pierced. Replace them if they are damaged.
q
Check the condition of the rubber gasket (fig. D – No. 6). Replace if necessary.
r
Refit the filter elements, wing nut, then the cover and its nut.
7.6. Starter battery maintenance
Never place the battery close to a flame or fire
Use only insulated tools
Never use sulphuric acid or acid water to top up the electrolyte level.
Danger
As the battery is maintenance-free, just check the condition and tightness of the connections and its general cleanliness.
7.7. Cleaning the generating set
Cleaning with a water jet is not recommended.
Cleaning with high pressure cleaning equipment is forbidden.
Important
n
Remove all dust and debris from around the exhaust.
o
Clean the generating set, particularly the alternator and engine air inlets and outlets, using a cloth and brush.
p
Check the general condition of the generating set and replace any faulty parts.
8. Storing the generating set
If the generating set is not used for a long period, it must be stored in accordance with the guidelines below.
n
Using a suitable container, drain out the fuel and replace the fuel filter ( see § Fuel filter replacement )
o
Start the generating set and allow it to run until it stops due to lack of fuel .
p
With the engine still warm, change the engine oil and replace the oil filter (see § Renewing engine oil & Replacement of the oil
filter).
q
Clean the air filter (see § Cleaning the air filter) .
r
Clean the exterior of the generating set, apply an anti-rust product onto the damaged areas.
s
Cover the generating set with a drop cloth to protect it from dust and store it in a clean & dry location.