Scytek electronic 2000RS, Руководство по эксплуатации продукта

Страница: 25 / 48

Galaxy 5000/2000RS-DBP - Page 21
Panic Mode
In the event of an emergency, the transmitter’s remote Panic feature can be used to instantly trigger the
alarm/panic feature.
To activate the Panic Mode:
1. Press and hold Button 1 for five seconds.
· The alarm will sound.
· The parking lights will flash.
· The doors will unlock** allowing access to the vehicle.
2. Press Button 1 or 2 to stop Panic Mode.
**If the ignition is on when the Panic feature is activated, the doors will lock for personal safety.
If not deactivated using Buttons 1 or 2, the Panic Mode will automatically exit after 30 seconds and the
system will be restored to its previous Armed/Lock or Disarmed/Unlocked state.
* Emergency Override
If the transmitter becomes lost or inoperable, the system can still be disarmed using the following
procedure. Before beginning this procedure be sure to have the ignition key ready and know the location
of the override switch.
To Emergency Override the system:
1. Unlock the door using the key.
2. Enter the vehicle.
· The system will trigger and the siren will sound.
3. Turn the ignition key to the ON position.
4. Press and hold the override switch until the alarm turns off (approximetly 10sec)
· The system will disarm.
5. The vehicle will now be able to start.
Optional Coded Emergency Override
As an extra measure of security, the Galaxy 5000/2000RS-DBP Series is equipped with an optional Coded
Emergency Override feature. Once an Emergency Override Code is chosen and programmed during
installation, the system can no longer be disarmed using the standard override procedure.
To Emergency Override the system using the Code:
1. Follow steps 1-3 above.
2. Press the override switch a number of times equal to the Disarm code of you have chosen, and
continue holding for 10 seconds on the last press.
· The system will disarm. If the code is entered incorrectly, turn off the ignition and begin again.
To set the Emergency Override Code:
1. Turn the ignition switch to the ON position.
2. Within 5 seconds, press the valet switch 5 times.
· The siren will provide one long chirp indicating that you have entered Programming.