SCOPE COMMUNICATIONS UK LTD
PAGETEK PRO MK2
Ref: PTPROMK2INSTALLred
Page
10
of 27
Issue 1
3.4 Fitting the antenna
a) For the 3/4UHF and LUHF antennas, insert the connector end through the blanking
grommet into the top of the case and slide the connector onto the male BNC located at the
top of the transmitter board, then twist in a clockwise direction to lock it in place.
b) Slide the blanking grommet down the shaft of the antenna (or cable) and compress the
rubber mount until the groove is fully seated in the top plate hole. See diagram 4.
c) For the FUHFDP remote mounted antenna, a fixed cable gland has been pre-fitted onto
the cable.
d) Remove the nut from the gland and off the end of the cable. Insert the cable mounted
BNC connector through the top plate hole and thread the nut back onto the cable from
inside the case. Locate the cable gland in the top plate hole and tighten the nut to lock it in
place. Now fit the BNC connector to the transmitter board as in (a) above.
