Scientific Atlanta PowerVu D9234, Инструкция по установке и эксплуатации

Страница: 43 / 78

$YDLODEOH6HUYLFHVPHQX
Information about available satellite broadcast services and the current setup is
available from the Available Services menu. These services are authorized through
your dealer/reseller or local service provider. The current setup is also affected by
your LNB antenna (dish) installation.
To display the Available Services menu
Step 1. Display the Main Menu (Figure 7).
Step 2. Move to Available Services and press SELECT.
Available options: Move to Exit and press SELECT (or press 1 and then SELECT)
to return to the previous menu.
You can view information about the current setup. The following available satellite
broadcast services information is displayed on-screen.
‰ Video (PID) 1
‰ Audio (PID)
‰ LS Data 2 (PID)
‰ WB Data (PID)
‰ CONTROL (control pins status)
‰ VBI (PID) 3
‰ Download (PID)
‰ Channel (current channel number)
‰ Encryption (status)
‰ Scrambling (status)
‰ Authorization (status)
1
Packet ID
2
Low Speed Data
3
Vertical Blanking Interval
«$ERXWVXEVFULEHUVHUYLFHV
Subscriber uplink services made available to your Business Satellite Receiver are
associated with virtual channels. These channels can include video, audio and/or
data services. All authorized virtual channel services are provided via PowerVu
Command Center (PCC) system software and broadcast facility equipment, and are
decoded by the receiver using the current receiver setup. You can view available
subscriber services information independently (i.e., for each virtual channel) from
the Available Services menu. If subscriber services are not authorized or are
authorized for specific virtual channels only, an on-screen message is substituted
for the virtual channel display, and the Authorized field displays “No” to indicate
that no uplink service authorization key is being received. For more information
about Wideband Data, see “Connecting your system”.
If EXPANSION PORT control pins are being used for remote receiver operation via
Serial Remote Control commands, the status of each pin is displayed at the Control
field. For example, if all four control pins are set to the open collector state
(i.e., High), the Control field displays “HHHH”. For more information about the
EXPANSION PORT, see “Connecting your system” (see also “Appendix C Serial
Remote Control Command Set”).
For more information about screen messages, see “Appendix B Troubleshooting”.
Figure 14. Available Services menu display