Scientific Atlanta PowerVu D9234 страница 17 Скачать руководство пользователя

Страница: 17 / 78

79 5)SOXVRSWLRQDOFRQQHFWLRQV

The accompanying figure shows the cable connections required for the satellite
LNB and TV monitor plus other (optional) connections that can be made from the
rear panel of your Business Satellite Receiver. As many, different equipment con-
figurations are possible, use the following information as a guide only. If you need
assistance to identify your specific equipment configuration needs, contact your
dealer/reseller or local service provider (see also “Connecting your system").

TV tuner/converter channel setting

NTSC models only:

Set the TV modulator selector switch (near TV OUT connector) to

the correct channel for receiving video signals via your TV tuner/converter

PAL models only:

(1) Switch the receiver ON [press the ON/STANDBY button] (2) Set

the TSG (Test Signal Generator) switch (near ANT IN connector) to ON for displaying the
output test signal (3) Set the TV modulator rotary selector switch (near UHF OUT co

nector) to the correct channel for receiving video signals via your TV tuner/converter

Note:

After setting the correct PAL tuner/converter channel, be sure to set the TSG

switch to OFF, or the normal TV signal will not be available

Satellite antenna LNB and TV monitor connection

Connect the coaxial RF cable from the satellite antenna LNB to the receiver RF IN jack

Connect a coaxial RF cable from the receiver TV OUT jack to the VHF IN jack of your

(Hint: Some VCRs and TVs label this connection RF IN, VHF IN or UHF/VHF IN)

CATV/CCTV cable or terrestrial VHF/UHF TV antenna connection

Connect the coaxial RF cable from the external cable/TV source or terrestrial VHF/UHF
antenna to the receiver ANT IN jack

VCR connection

Connect shielded A/V cables from the L (Left) and R (Right) receiver AUDIO jacks and
VIDEO jack to the AUDIO IN and VIDEO IN jacks of your VCR

S-Video (S-VHS) TV or VCR connection

Connect a cable from the receiver S-VIDEO connector to the S-Video connector on your
TV or VCR (see

also

Connecting your system).

SCART TV or VCR connection

PAL models only:

Connect a SCART cable from the receiver TV/VCR (SCART) connector

(see Figure 3 on previous page) to the SCART connector on your TV or VCR

Note:

Connecting a SCART cable directly to your TV monitor or VCR permits some or all

of the separate video/audio connections to be safely removed or switched out without
affecting receiver video and/or audio output signals

EXPANSION PORT connection

Connect a shielded 25-pin D cable from the receiver EXPANSION PORT to the data port
of your PC/workstation or data terminal (see

Table 1 on previous page for EXPANSION

PORT connector pin-out)

WIDEBAND DATA port connection

Connect a shielded 9-pin D cable from the receiver WIDEBAND DATA port to the data
port of your PC/workstation, data terminal or other (special) data communications
equipment (see Table 2 on previous page for WIDEBAND DATA port conne

ctor pin-out)

6$7(//,7(

$&,1

/1%3:5

9P$

9$&

$0$;

:,'(%$1''$7$

Scientific

Atlanta

Satellite Television Network Division

9,'(2 69,'(2