8
Console Service Mode
Service Mode lets you set the units of measure to either English or Metric, see machine statistics and firmware version (for technician
use only).
1.
When the Console is in Workout Mode or Pause Mode, push and hold down the button for 5 seconds to go into Service Mode.
Note:
Tap the button to move through the Service Mode Menu options. When the Console display shows “dOnE”, push and hold
the button for 3 seconds to reset the workout data and go back to Workout Mode.
2.
The Console display shows the Units prompt. Push and hold the button to start Units option. Push the button to change between
“LbS” (English units) and “SI” (metric units).
3.
Push and hold the button for 3 seconds to set the units. The Console display shows the Units prompt.
4.
Push the button to go to the Stats prompt. Push and hold the button to start the machine Stats option. The Console display shows
Total Distance. Push the button to change between Total Distance and Total Time.
Note:
The Total Distance value is a whole number of miles/km (no decimal point).
5.
Push and hold the button for 3 seconds to go back to the Stats prompt.
6.
Push the button to go to the Firmware Version prompt. Push and hold the button to see the firmware version of the Console.
7.
Push and hold the button for 3 seconds to go back to the Firmware Version prompt.
8.
Push the button to go to the exit option. The Console display shows “dOnE”.
To go back to Workout Mode, push and hold the button for 3 seconds. The workout data is reset.
To go through the Service Mode Menu again, tap the button. The Console display will show the Units prompt.
In Service Mode if the Console does not receive any input in approximately 5 minutes, it goes into Sleep Mode.