44
5.
To loosen the Flywheel hardware, use a 15 mm crescent
wrench to hold the Axle Nut (D) on one side steady and loosen the
Axle Nut on the opposite side with a 15 mm socket and wrench.
Remove the Axle Nuts from the Flywheel axle (E). Set the hardware
safely aside for reassembly.
6.
Loosen the Hex Head Bolt (C) that attaches each Flywheel
Retainer Clip (A) to the Frame. Remove the Hex Head Bolts,
Flywheel Retainer Clips and Nuts (F) from the Frame, and set aside
to discard.
7.
Installation is the reverse procedure.
NOTICE:
Do not crimp any cables. Install the new Flywheel
Retainer Clips (A) at the position that you recorded in
step 4. Make sure the Flywheel (G) can turn easily.
8.
Make sure that the Drive Chain tension is correct. Refer to the
“Adjust the Chain Tension” procedure.
9. Final
Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner’s Manual.
A
B
E
D
D
B
E
C
A
F
X2
